CeRVaNTeS' arm and base control (maxon+epos2)

< go back to main

---

Related articles	Other articles
CeRVaNTeS' arm model for simulation (urdf+gazebo) CeRVaNTeS model for simulation (urdf+gazebo) Integration of CeRVaNTeS in moveIt! (gazebo+moveIt!) CeRVaNTeS' Teleoperation with xbox360 wireless controller (xbox360 controller+joy)	MYRAbot's arm control (bioloid+arduino) Objects recognition and position calculation (webcam) MYRAbot's arm model for simulation (urdf+gazebo) MYRAbot model for simulation (urdf+gazebo) Integration of MYRAbot in moveIt! (gazebo+moveIt!) Voice control (sphinx+festival) MYRAbot's Teleoperation with xbox360 wireless controller (xbox360 controller+joy)

---

Maxon motors arm and base

The drives of the arm and base are compound by the elements shown below:

Arm

• Shoulder (turn/tilt) = 2 motorsMaxon RE 30 (60W) + 2 Epos2 controllers + 2 Planetary Gearheads 246:1 + 2 incremental encoders 1024cpt
• Elbow (turn/tilt) = 2 motors Maxon RE-max 29 (22W) + 2 Epos2 controllers + 2 Planetary Gearheads 246:1 + 2 incremental encoders 1024cpt
• Wrist(turn) = 1 motor Maxon A-max 22 (6W) + 1 controladora Epos2 + 1 reductora planetaria 270:1 + 1 incremental encoder 1024cpt
• Wrist (tilt/inclination) = 2 motors Maxon EC 20 flat (5W) + + 2 Epos2 controllers + 2 Planetary Gearheads 270:1 + sensor Hall 16cpt

Note: There is a potentiometer in each joint of the arm in order to know the absolute position of the arm joints.

Base

• Base (left/right wheel) = 2 motors Maxon RE-max 29 (22W) + 2 Epos2 controllers + 2 Planetary Gearheads 86:1 + 2 incremental encoders 2048cpt

Note: The Epos2 controllers are connected to a CANopen bus, each controller have a unique ID. The PC is plugged to USB port of the initial controller and it works like master.

ROS y Epos2

We have based on wpi-rover project to realize the driver for the communication between ROS and the Maxon's Epos2 controllers. This project consists of a ROS wrapper or package that uses the Epos2's linux libraries.

< go back to main